Document ID: OMM-00131 Rev. E
16
3.5.2 Install Printer Feet
Install the printer feet as follows:
1. The Printer Feet are threaded and include an adjustment nut and
a lock nut. as shown.
2. While the printer is on the fork lift or pallet jack, install the feet
by screwing the threaded shaft into the installation location next
to the printer wheels.
There are four installation locations, one adjacent to each
printer wheel.
Figure 3-4: Printer Foot Detail
1Adjustment Nut
2Lock Nut
1
2
Figure 3-5: Printer Installation Location
1 Printer Wheels 2 Printer Foot
3 Foot Installation Location
1
2
3
To Next Page
Loading...
