Document ID: OMM-00131 Rev. E
19
3.6.2 Adjusting the Leveling Feet
Level the printer front-to-back and side-to-side as described in this paragraph. It is important to make all adjustments with the
levels in place. Make adjustments for leveling front-to-back and side-to-side at the same time.
1. Use an adjustable wrench, rotate the foot so that it moves
up or down.
2. Check the levels to ensure the printer is leveling out as
each foot is adjusted.
3. Ensure printer is level in all directions.
4. Carefully observe the left and right levels to avoid printer
“twist”.
5. When satisfied that he printer is level in all directions,
tighten the lock nuts so the feet are securely fastened and
will not loosen.
4 Inches
Figure 3-9: Printer Foot Measurement
Secure Locknut
Adjust Height
with Wrench
Figure 3-10: Leveling Feet Adjustments
To Next Page
Loading...
