Document ID: OMM-00131 Rev. E
30
3.9.2 Feed Roll Assembly Installation
The Feed Roll Assembly is installed on the rear of the printer (opposite the operator station). A brief overview of this
installation is provided below. Detailed Assembly is provided in the Exploded View shown in
Figure 3-25.
1. Install and level the Motor Side Plate on the left side of the printer.
2. Install and level the Guide Side Plate on the right side of the printer.
3. Install the Media Support Chucks onto the Media Roll and place the Media Roll into the upper guides on the side plates.
4. Using the appropriate hardware supplied, assemble the Media Feed Handling System as shown.
Figure 3-24: Feed Roll Assembly Installation Overview
1 Motor Plate 2 Dancer 3 Media Roll
4 Right Side Plate 5 Dancer Stop 6 Media Support Chucks
1
2
3
4
5
6
To Next Page
Loading...
