03-2009 SOI/DT-mdm FCPD-dp Quality-fz 10/91 599 70 56-70
10
- Reading/Cancellation of the last
alarm
----- ----
(*) In most cases, this time is sufficient to check the heating. However, the time can be increased by
repeating the phase without draining the water: pass for a moment to a different phase of the diagnostic
cycle and then back to the heating control phase (if the temperature is higher than 80°C, heating does
not take place).
(**) The check at the maximum speed occurs without control of the FUCS and no clothes have to be
inserted inside the appliance.
To Next Page