03-2009 SOI/DT-mdm FCPD-dp Quality-fz 11/91 599 70 56-70
5 ALARMS
5.1 Displaying the alarms to the user
The alarms displayed to the user are listed below:
ª Door open
ª Drain difficulty (dirty filter)
ª Water fill difficulty (closet tap)
AEG Version
The alarms are represented through the flashing of the yellow LED, which is above
the START-PAUSE button, and can be solved directly by the end user;
Other versions
The alarms are represented through the flashing of the red LED, which is inside
the START-PAUSE button its shape depends on the styling) and can be solved
directly by the user;
The alarm listed below:
ª EF0 – Water leakage (Aqua Control System)
for its solution it is necessary the intervention of the Service.
While for the alarm:
ª EH0 – Voltage or frequency out of nominal values
It is necessary to wait that the voltage and/or the frequency of the electric line reset the nominal
conditions.
The alarms are enabled during the execution of the washing programme, with the exception of alarms
associated with configuration and the power supply (voltage/frequency), which are also displayed during the
programme selection phase.
The door can normally be opened (except where specified) when an alarm condition has occurred on
condition that:
• The level of the water in the tub is below a certain level
• Water temperature lower than 55°C
• Motor stopped
Certain alarm conditions require that a drain phase be performed before the door can be opened for safety
reasons:
• Cooling water fill if the temperature is higher than 65°C
• Drain until the analogue pressure switch is on empty, during a max. 3-minute time.
To Next Page
Loading...
Need help?
General
