EasyManuals Logo

Elmo MA-1 User Manual

Elmo MA-1
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
4
USAGE PRECAUTIONS
Be sure to use the AC adapter.
The supplied AC adapter is designed for exclusive use with this product. Do not use it
with other products.
Do not press the touchscreen strongly by finger or sharp objects. This can cause
damage or malfunction.
Be careful not to pinch your finger when you move the arm or touchscreen.
A protective sheet is attached to the surface of the touchscreen. Remove it before you
use the product.
The AC adapter appropriate for the country where it is used is supplied with the product.
If the product was sold in Japan, use the AC adapter sold with the product with 100 VAC
and 50 or 60 Hz.
When storing the product, do not leave it under direct sunlight or by heaters. It may be
discolored, deformed, or damaged.
Do not place the product in any humid, dusty, salt bearing wind, or vibrating locations.
Use it under the following environmental conditions:
Temperature0℃~ 40 Humidity30%~ 85(No condensation)
Do not use the product in an environment where the temperature of the product
becomes too hot, such as under direct sunlight or by heaters. The product will
automatically stop the operation to protect the battery when the internal temperature
reaches 65.
Use a soft, dry cloth for cleaning. Do not use any volatile solvent such as thinner or
benzene.
Luminescent and Black Spots
There may be some pixels that do not properly operate due to the use of CMOS Area
Image Sensors made-up of many pixels.
Though luminescent or black spots may be found on the screen, it is a phenomenon
peculiar to the CMOS Area Image Sensors and is not a malfunction.
Follow the guidelines below to prevent the product from dropping or overturning.
- Use the product on a stable base, desk, or table. Do not place the product on an
unstable base or slanted location.
- Place or wire the product so as to prevent the cables from being pulled or drawn.
Do not point the lens directly to the sun. It could degrade the imaging capability.
Do not look directly into the LED light. If you look directly into it at pointblank range,
your eyes may be injured.
Some type of SD card/USB flash drive can be used.
Transfer the data saved in the recording media (such as the internal storage, SD card
and USB flash drive) to a device such as a PC to save a backup copy. Malfunction of the
product or repairs to it may cause the data to be deleted.
ELMO is not liable for any damage caused by the loss or damage of the data in the
recording media.
Disposal of battery
This product uses Lithium Ion rechargeable and recyclable battery.
When disposing of the battery, contact the dealer from whom you purchased the
product. Do not try to remove the battery by yourself.
If the product is used for longer than the warranty period, its performance and quality
may deteriorate due to the lifetime of its parts. For parts replacement (on chargeable

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Elmo MA-1 and is the answer not in the manual?

Elmo MA-1 Specifications

General IconGeneral
BrandElmo
ModelMA-1
CategoryDocument Camera
LanguageEnglish

Related product manuals