24
9500
Needle
(A)
Needle plate
Adjusting Height of Embroidery Foot P
Space between the needle plate and the bottom surface of the Foot (P) should be
0.7 to 1.5 mm, when the needle bar is at its lowest position.
1 Set the pressure dial at “2” and remove the
top cover.
2Lower the needle bar and lower the presser bar
lifter.
3 Insert the 1.2 mm Thickness gauge between
the Embroidery Foot (P) and the needle plate.
4While pressing the Pressure bar actuator down
against the upper shaft cam, loosen the Screw (A)
and push it down to the direction of arrow, then
tighten Screw (A) again.
5 Reattach the rear cover.
(Set the Pressure dial at “3”.)
NOTE: After this adjustment, must perform “Foot
sensor adjustment”. (See page 32)
q
w
e
q
w
e
To Next Page
