ELNA 9500 - Adjusting Thread Drawing Lever

40
9500
5.45 - 5.75 mm
VIEW - X
VIEW – A


Adjusting Thread Drawing Lever
The standard height of the thread drawing lever from the surface of bobbin holder
should bein the range of 5.45 - 5.75 mm.
1 Remove the needle plate.
2 Loosen thehe hxagonal bolt and adjust distance of
the thread drawing lever from the bobbin holder
should be in 1.3 mm by move the thread drawing
lever up or down.
3 Tighten the hexagonal bolt.
4 Attach the needle plate
q
q
w
w
e
e