Embedded Systems LogiMachine5 Power - 12.4. RTU Settings

179
 Scan range start – start ModBus device address
 Scan range end – end ModBus device address
12.4. RTU settings
 RTU ( serial) enabled – defines either Modbus RTU is enabled
 Port (/dev/RS485-1; /dev/RS485-2) – specify the port to communicate or leave blank for
automatic detection.
 Baud rate (1200 .. 500000) – baud rate
 Parity (None 1 stop bit; Odd, Even, None 2 stop bits) – parity
 Duplex – define either half or full duplex communication