EasyManua.ls Logo

Embedded Systems LogiMachine5 Power - Page 18

Embedded Systems LogiMachine5 Power
254 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
In System configuration
Network
Interfaces window click on the specific interface to
change the IP settings.
Protocol specific protocol used for addressing
o Static IP static IP address. By default 192.168.0.10
o DHCP use DHCP protocol to get IP configuration.
Current IP the IP address got from DHCP server. This field appears only if
the IP 
Network mask network mask. By default 255.255.255.0 (/24)
Gateway IP gateway IP address
DNS server DNS server IP address
MTU maximum transmission unit, the largest size of the packet which could be passed
in the communication protocol. By default 1500
When changes are done, the following icon appears in the top-right corner. This should be
applied changes to take effect.

Table of Contents