Emerson Network Power TD3200 Series User Manual

Chapter 3 Installation and Wiring 15
TD3200
VCC
0 V
A
●
●
●
B
●
using shielding cable
closer end of
shielding cable is
connected to PE
PG of open collector
output type (The part
in dashed line is the
PG of voltage output
type
）
0V
0V
P24
PE
COM
●
●
●
●
B
Interface
circuit is
same with A
●
A
3.3V
VCC
VCC
X1
x2
Figure 3-6 Wiring of PG of open collector output type
2. Wiring with 24V power supply (push-pull output type)
TD3200
P24
PE
COM
X1
●
●
●
X2
●
B
Interface
circuit is
same with
A
●
3.3V
A
0 V
A
PG of
push-pull
type
●
●
●
●
B
using shielding
cable
closer end of
shielding cable is
connected to PE
VCC
VCC
GND
VCC
GND
Using shielding cable
Figure 3-7 Wiring of PG of push-pull output type
If the signal is single-phase PG signal, then it must be input via terminal X1.
3.3.4 Wiring Requirements
1. MCCB used for overcurrent protection must be installed between AC
power and the drive, and it must be fixed inside the cabinet;
2. The cable diameter and MCCB capacity should be selected according to
the table below:
TD3200 Variable Speed Drive for Elevator Door Control User Manual

Emerson Network Power TD3200 Series Specifications

General

Brand	Emerson Network Power
Model	TD3200 Series
Category	Control Unit
Language	English