Emerson Aventics G3 Series - Hub Module: Factory Defaults

G3 Series EtherCAT
TM
Technical Manual
11-119
TDG3ECM1-5EN 07/2020
Subject to change without notice
www.asco.com/g3
Factory Defaults
4) Allows all parameter settings to be set back to
default values.
A) Press the SET button to enter the Factory
Defaults sub menu.
B) Press the NEXT button to choose Yes or No.
C) Press the SET button to confirm.
D) Press the SET button again.
Factory Default Settings
Brightness
Medium
Flip Display
Normal
Reserve I/O
No Reserve (all Branches)
NOTE!
FACTORY
DEFAULTS
SET DEFAULTS
YES NO
RESETTING