G3 Series EtherCAT
TM
Technical Manual
13-128
Subject to change without notice
www.asco.com/g3
8. Click on “Internet Protocol Version 4 (TCP/IPv4)” the properties window will open
9. Choose the option marked “Use the following IP address” and type in an IP address that has the same first
three octets as the address as you the manifold you are connected with. For the last octet you may choose
any number from 0-255, just make sure that it is not the same number as the IP address that the manifold
will have. Make sure your subnet mask is set to “255.255.255.0” (this value can be changed, but this value
will be used for demonstration purposes).
To Next Page
Loading...
