188 CG Drives & Automation 01-7492-01r1
Here the menu shows the run time when the trip occurred.
Fig. 149
Fig. 149 shows the third trip memory menu [810]: Over
temperature trip occurred after 1396 hours and 13 minutes
in Run time.
For Fieldbus integer value of trip message, see message table
for Warning [722].
Trip message [811]-[81Q]
The information from the status menus are copied to the
trip message log when a trip occurs.
Trip Messages [820] - [890]
Same information as for menu [810].
All nine alarm lists contain the same type of data. For
example DeviceNet parameter 31101 in alarm list 1
contains the same data information as 31151 in alarm list 2.
See Menu List chapter 15. page 227.
Reset Trip Log [8A0]
Resets the content of the 9 trip memories.
810 0rpm
Over temp
1396:13:00
Sby Rem/Rem
NOTE: Bits 0–5 used for trip message value. Bits 6–15
for internal use.
Trip men u
Copied
from
Description
811 711 Process Value
812 712 Speed
813 713 Torque
814 714 Shaft Power
815 715 Electrical Power
816 716 Current
817 717 Output voltage
818 718 Frequency
819 719 DC voltage
81A 71A IGBT Temperature
81B 71B PT100 1, 2, 3
81C 721 VSD Status
81D 723 Digital input status
81E 724 Digital output status
81F 725 Analogue input status 1-2
81G 726 Analogue input status 3-4
81H 727 Analogue output status 1-2
81I 728 I/O status option board 1
81J 729 I/O status option board 2
81K 72A I/O status option board 3
81L 731 Run Time
81M 732 Mains Time
81N 733 Energy
81O 310 Set/View ref
81P 72C VIO Status
81Q 71C PT100 4, 5, 6
8A0 Reset Trip L
Default: No
No 0
Yes 1
NOTE: After the reset the setting goes automatically
back to “NO”. The message “OK” is displayed for 2
sec.
Trip menu
Copied
from
Description
To Next Page
Loading...
Need help?
General
