Safety instructions Biometra TRIO
12
Keep ventilation slits clear Keep the ventilation slits on the underside
and at the rear of the device clear. Make
sure that there are no objects underneath
the device (e.g., paper) that may be sucked
against the ventilation slot and thus inter-
fere with ventilation.
2.3 Technical condition
The Biometra TRIO has been built and certified according to safety standard EN 61010-
1. Do not modify the device in any way. Any modification of the device will lead to a loss
of warranty and the EN 61010-1 certificate and poses a potential risk.
The following has to be observed:
The operator must only operate the device in a sound and operationally safe condi-
tion. The technical condition must always comply with the legal requirements and
regulations.
Prior to every use the device must be checked for damage and sound condition.
Any changes in the device affecting its safety must be reported by the operating per-
sonnel to the operator without delay.
2.4 Requirements for the operating personnel
The Biometra TRIO must only be operated by qualified specialist personnel instructed in
the use of the device. The instructions also include imparting the contents of this man-
ual.
In addition to the safety at work instructions in this operating manual the generally ap-
plicable safety and accident prevention regulations of the respective country of opera-
tion must be observed and adhered to. The operator must ascertain the latest version of
these regulations.
The operating manual must be accessible to the operating and service personnel at all
times.
2.5 Safety instructions: transport and installation
The following has to be observed:
Drain the sample block before transporting the Biometra TRIO. Make sure there are
no sample tubes in the block.
Only ship the Biometra TRIO in its original packaging.
Please verify that the delivery is complete on receipt of the Biometra TRIO and check
for possible transport damage. In case of claims please contact Biometra GmbH.
To Next Page
Loading...
