Endress+Hauser Analytik Jena Biometra TRIO - Set Date and Time; Fig. 49 Biometra TRIO Settings Screen

Biometra TRIO Tools
77
Date and Time Set date and time See section "Set Date and Time" p. 77
Automatic user
logout
Switch automatic user logout on or off and
time settings
See section "Automatic user logout" p. 78
Beeper Switch beeper on or off See section "Config. Beeper" p. 79
Network Define network settings or list network users See section "Network" p. 80
Display Brightness Adjust display contrast See section "Display brightness" p. 82
Touch Screen
Calibration
Calibrate touch screen See section "Touch screen calibration" p. 83
Factory Settings Reset the settings See section "Factory settings" p. 83
Fig. 49 Biometra TRIO settings screen
Press the corresponding button to access the desired function.
11.1.1 Set Date and Time
Note: Date and time can only be edited by users with the right “System configuration”
activated (see section "Edit user" p. 88).
Enable a user to config. the system
configuration
The Biometra TRIO software allows the user to set time and date. The date is defined in
day:month:year and the time in hours:minutes:seconds.