Endress+Hauser Analytik Jena Biometra TRIO - Fig. 17 Biometra TRIO Graphical Programming Screen

Creating, editing and saving programs Biometra TRIO
44
Fig. 17 Biometra TRIO graphical programming screen
Both programming modes show the same information but in different ways. In the
spreadsheet mode all parameters are summarized in a table. In the graphical mode for
some parameters symbols are displayed (see table below). Toggle to the spreadsheet
mode to view the settings for these parameters.
Parameter Spreadsheet mode Graphical mode Section
Program name
① ①
See section 7.3
Heated lid temperature °C
② ②
See section 7.4
Preheat lid mode
③ ③
See section 7.5
Step number
④ ④
See section 7.6
Temperature °C
⑤ ⑤
See section 7.6
Holding time hh:mm:ss
⑥ ⑥
See section 7.6
Goto
⑦, ⑫ ⑦
See section 7.6.1
Cycles
⑧, ⑬ ⑧
See section 7.6.1
Temperature increment ∆T (°C)
⑨ ⑨
See section 7.6.2
Time increment ∆t (s)
⑩ ⑩
See section 7.6.3
Ramping rate [∆R (°C/s)
⑪
⑪
See section 7.6.4
TOS step
⑭ ⑭
See section 7.6.5
If a program has more than 6 steps, use the cursor keys to navigate in the spreadsheet
or the graphical display.