Troubleshooting Proline Promag 55 PROFIBUS DP/PA
140 Endress+Hauser
9.7 Return
"
Caution!
Do not return a measuring device if you are not absolutely certain that all traces of hazardous
substances have been removed, e.g. substances which have penetrated crevices or diffused through
plastic.
Costs incurred for waste disposal and injury (burns, etc.) due to inadequate cleaning will be charged
to the owner-operator.
The following steps must be taken before returning a flow measuring device to Endress+Hauser,
e.g. for repair or calibration:
• Always enclose a duly completed "Declaration of contamination" form. Only then can
Endress+Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per
EC REACH Regulation No. 1907/2006.
• Remove all residues. Pay special attention to the grooves for seals and crevices which could
contain residues. This is particularly important if the substance is hazardous to health, e.g.
flammable, toxic, caustic, carcinogenic, etc.
!
Note!
You will find a preprinted "Declaration of contamination" form at the back of this Operating Manual.
9.8 Disposal
Please observe the regulations applicable in your country or region.
9.9 Software history
Date Software version Changes to software Documentation
02.2011 PROFIBUS DP/PA
3.06.XX
No change to software 71130401/13.11
06.2010 PROFIBUS DP/PA
3.06.XX
Introduction of a new PROFIBUS DP I/O board 71116509/06.10
12.2007 PROFIBUS PA
3.05.XX
Introduction of a new PROFIBUS PA I/O board 71065431/12.07
09.2006 PROFIBUS PA
2.03.XX
Original software 71028542/09.06
To Next Page
Loading...
