Endress+Hauser Proline Promag 55 - Turning the Transmitter Housing

Proline Promag 55 PROFIBUS DP/PA Installation
Endress+Hauser 31
3.3.3 Turning the transmitter housing
Turning the aluminum field housing
1. Loosen the two securing screws.
2. Turn the bayonet catch as far as it will go.
3. Carefully lift the transmitter housing as far as it will go.
4. Turn the transmitter housing to the desired position (max. 2 × 90° in either direction).
5. Lower the housing into position and reengage the bayonet catch.
6. Retighten the two securing screws.
A0004302
Fig. 22: Turning the transmitter housing (aluminum field housing)
Turning the stainless-steel field housing
1. Loosen the two securing screws.
2. Carefully lift the transmitter housing as far as it will go.
3. Turn the transmitter housing to the desired position (max. 2 × 90° in either direction).
4. Lower the housing into position.
5. Retighten the two securing screws.
A0004303
Fig. 23: Turning the transmitter housing (stainless-steel field housing)
3
5
6
1
2
4
1
2
3
4
5