Endress+Hauser Proline Promag 55 - Turning the Local Display

Installation Proline Promag 55 PROFIBUS DP/PA
32 Endress+Hauser
3.3.4 Turning the local display
1. Unscrew the electronics compartment cover from the transmitter housing.
2. Press the latches on the side of the display module and pull the module out of the electronics
compartment cover.
3. Turn the display to the desired position (max. 4 × 45° in both directions) and position it back
on the electronics compartment cover.
4. Screw the cover of the electronics compartment firmly back onto the transmitter housing.
A0003236
Fig. 24: Turning the local display (field housing)
4 x 45°