Endress+Hauser Proline Promag 55 - 10.1.12 Certificates and Approvals

Proline Promag 55 PROFIBUS DP/PA Technical data
Endress+Hauser 155
10.1.12 Certificates and approvals
CE mark The measuring system described in these Operating Instructions therefore complies with the legal
requirements of the EU Directives. Endress+Hauser confirms this by affixing the CE mark to it and
by issuing the CE declaration of conformity.
C-tick mark The measuring system meets the EMC requirements of the "Australian Communications and Media
Authority (ACMA)".
Ex approval Information on the currently available Ex-rated versions (ATEX, FM, CSA, etc.) is available on
request from your Endress+Hauser sales outlet. All explosion protection data are given in a separate
documentation which is available upon request.
Sanitary compatibility Promag S
no applicable approvals or certification
Promag H
• 3A authorization and EHEDG-tested
• Seals in conformity with FDA (except Kalrez seals)
Certification PROFIBUS The flowmeter has successfully passed all the test procedures carried out and is certified and
registered by the PNO (PROFIBUS User Organization). The device thus meets all the requirements
of the following specifications:
• Certified in accordance with PROFIBUS Profile Version 3.0 (device certification number: available
on request)
• The measuring device can also be operated with certified devices of other manufacturers
(interoperability).
Pressure measuring device
approval
The measuring devices can be ordered with or without PED (Pressure Equipment Directive). If a
device with PED is required, this must be ordered explicitly. For devices with nominal diameters
less than or equal to DN 25 (1"), this is neither possible nor necessary.
• With the identification PED/G1/III on the sensor nameplate, Endress+Hauser confirms
conformity with the "Basic safety requirements" of Appendix I of the Pressure Equipment
Directive 97/23/EC.
• Devices with this identification (with PED) are suitable for the following types of fluid:
– Fluids of Group 1 and 2 with a steam pressure of greater or less than 0.5 bar (7.3 psi)
– Unstable gases
• Devices without this identification (without PED) are designed and manufactured according to
good engineering practice. They correspond to the requirements of Art. 3, Section 3 of the
Pressure Equipment Directive 97/23/EC. Their application is illustrated in Diagrams 6 to 9 in
Appendix II of the Pressure Equipment Directive 97/23/EC.
Other standards and
guidelines
• EN 60529
Degrees of protection by housing (IP code)
• EN 61010-1
Protection Measures for Electrical Equipment for Measurement, Control, Regulation and
Laboratory Procedures.
• IEC/EN 61326
"Emission in accordance with requirements for class A".
Electromagnetic compatibility (EMC requirements).
• ANSI/ISA-S82.01
Safety Standard for Electrical and Electronic Test, Measuring, Controlling and related
Equipment - General Requirements. Pollution degree 2, Installation Category II.