Endress+Hauser Proline Promag 55 - Page 152

Technical data Proline Promag 55 PROFIBUS DP/PA
152 Endress+Hauser
Promag H
!
Note!
The following weights apply to standard pressure ratings and without packaging material.
Materials Promag S
Transmitter housing:
• Compact and remote version: Powder-coated die-cast aluminum
Sensor housing:
• DN 15 to 300 (½ to 12"): powder-coated die-cast aluminum
• DN 350 to 600 (14 to 24"): painted steel
Measuring tube:
• DN < 350 (14"): stainless steel 1.4301 or 1.4306/304L
Non-stainless flange material with Al/Zn protective coating.
• DN > 300 (12"): stainless steel 1.4301/304
For flanges made of carbon steel with protective varnish.
Flanges:
• EN 1092-1 (DIN 2501): 316L / 1.4571 (SS 316Ti); RSt37-2 (S235JRG2) / C22 / FE 410W B
(DN < 350/14": with Al/Zn protective coating; DN > 300/12" with protective varnish)
• ANSI: A105; F316L
(DN < 350/14" with Al/Zn protective coating; DN > 300/12" with protective varnish)
• JIS: RSt37-2 (S235JRG2) / HII / 1.0425 / 316L
(DN < 350/14" with Al/Zn protective coating; DN > 300/12" with protective varnish)
• AS 2129:
– DN 25 (1"): A105 or RSt37-2 (S235JRG2), with Al/Zn protective coating
– DN 50 (2"): A105 or St44-2 (S275JR), with Al/Zn protective coating
• AS 4087:
– DN 50 (2"): A105 or St44-2 (S275JR), with Al/Zn protective coating
Ground disks:
• 1.4435/316L
• Alloy C-22
Electrodes:
• 1.4435 (with tungsten carbide coating)
•Platinum
• Alloy C-22
•Tantalum
• Titanium Gr. 2
• Duplex 1.4462
• For brush electrodes:
– 1.4310/302
– Alloy X750
Seals:
• according to DIN EN 1514-1
Nominal
diameter
Promag H weight in pounds (lbs)
ANSI Compact version Remote version (without cable)
[inch] Sensor Transmitter
1/12" 11.5 4.4 13.5
5/32" 11.5 4.4 13.5
5/16" 11.7 4.4 13.5
½" 11.9 4.2 13.5
1" 12.1 5.1 13.5
Promag transmitter (compact version): 7.5 kg