Commissioning Proline Promag 55 PROFIBUS DP/PA
98 Endress+Hauser
Possible settings
!
Note!
The measured variables for the additional "advanced diagnostic" software are available only when
they are installed in the measuring device. If the measured variable is selected even if the additional
software is not installed, the value "0" is transmitted to the PROFIBUS master (Class 1) for the
measured variable.
Factory setting
Measured variable ID for "CHANNEL" function
VOLUME FLOW 273
MASS FLOW 277
The following measured variables are available when the additional "solids flow" software is installed
in the device (order option)
TARGET MASS FLOW 1164
% TARGET MASS FLOW 1165
TARGET VOLUME FLOW 1167
% TARGET VOLUME FLOW 1168
CARRIER MASS FLOW 1170
% CARRIER MASS FLOW 1171
CARRIER VOLUME FLOW 1172
% CARRIER VOLUME FLOW 1173
The following measured variables are available when the additional "advanced diagnostic" software is
installed (order option)
DEVIATION COATING 1 2341
DEVIATION COATING 2 2358
DEVIATION ELECTRODE POTENTIAL 1 2375
DEVIATION ELECTRODE POTENTIAL 2 2392
DEVIATION VOLUME FLOW 2419
DEVIATION NOISE VALUE 2443
Module Analog Input
function block
Measured variable ID for CHANNEL function
AI (slot 1) 1 VOLUME FLOW 273
AI (slot 5) 2 MASS FLOW 277
To Next Page
Loading...
