Endress+Hauser Proline Promass E 300 - Page 104

Commissioning Proline Promass E 300 PROFINET
104 Endress+Hauser
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Failure mode The Pulse option is selected in
the Operating mode
parameter (→  102) and a
process variable is selected in
the Assign pulse output
parameter (→  103).
Define output behavior in
alarm condition.
• Actual value
• No pulses
–
Invert output signal – Invert the output signal. • No
• Yes
–
* Visibility depends on order options or device settings
Configuring the frequency output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  105
Terminal number
→  105
Signal mode
→  105
Assign frequency output
→  106
Minimum frequency value
→  107
Maximum frequency value
→  107
Measuring value at minimum
frequency
→  107
Measuring value at maximum
frequency
→  107
Failure mode
→  107
Failure frequency
→  107
Invert output signal
→  107