Endress+Hauser Proline Promass F 300 - Page 155

Proline Promass F 300 EtherNet/IP Commissioning
155
Parameter Prerequisite Description Selection / User
entry
Factory setting
• Oscillation
amplitude 1
• Frequency
fluctuation 0
• Frequency
fluctuation 1
• Oscillation
damping 0
• Oscillation
damping 1
• Oscillation
damping
fluctuation 0
• Oscillation
damping
fluctuation 1
• Signal asymmetry
• Exciter current 0
• Exciter current 1
• HBSI
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Current output 1
• Current output 2
*
• Current output 3
*
• Current output 4
*
• Pressure
0% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 0% value for bar graph
display.
Signed floating-point
number
Country-specific:
• 0 kg/h
• 0 lb/min
100% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 100% value for bar
graph display.
Signed floating-point
number
0
Decimal places 3 A measured value is specified
in the Value 3 display
parameter.
Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx