Endress+Hauser Proline Promass F 300 - Page 165

Proline Promass F 300 EtherNet/IP Commissioning
165
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry / User
interface
Factory setting
Assign simulation process variable – Select a process variable for
the simulation process that is
activated.
• Off
• Mass flow
• Volume flow
• Corrected volume
flow
• Target volume
flow
• Carrier volume
flow
• Target corrected
volume flow
• Carrier corrected
volume flow
• Density
• Reference density
• Reference density
alternative
• GSV flow
• GSV flow
alternative
• NSV flow
• NSV flow
alternative
• S&W volume flow
• Water cut
• Oil density
• Water density
• Oil mass flow
• Water mass flow
• Oil volume flow
• Water volume flow
• Oil corrected
volume flow
• Water corrected
volume flow
• Weighted density
average
• Weighted
temperature
average
• Temperature
• Concentration
*
• Target mass flow
*
• Carrier mass flow
*
Off
Process variable value One of the following options is
selected in the Assign
simulation process variable
parameter (→  165):
• Mass flow
• Volume flow
• Corrected volume flow
• Density
• Reference density
• Temperature
• Concentration
*
• Target mass flow
*
• Carrier mass flow
*
Enter the simulation value for
the selected process variable.
Depends on the
process variable
selected
0