Endress+Hauser Proline Promass F 300 - Page 87

Proline Promass F 300 EtherNet/IP System integration
87
Possible input values
Possible input values 1 to 10:
• Off
• Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
1)
• Carrier mass flow
1)
• Target volume flow
1)
• Carrier volume flow
1)
• Target corrected volume flow
1)
• Carrier corrected volume flow
1)
• Density
• Reference density
• Concentration
1)
• Temperature
• Carrier tube temperature
2)
• Electronic temperature
• Oscillation frequency 0
• Oscillation frequency 1
2)
• Oscillation amplitude 0
• Oscillation amplitude 1
2)
• Frequency fluctuation 0
• Frequency fluctuation 1
2)
• Oscillation damping 0
• Oscillation damping 1
• Tube damping fluctuation 0
• Tube damping fluctuation 1
• Signal asymmetry
• Exciter current 0
• Exciter current 1
2)
• Monitoring of exciter current 0
• Monitoring of exciter current 1
2)
• HBSI
2)
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Alternative reference density
3)
• GSV flow
3)
• Alternative GSV flow
3)
• NSV flow
3)
• Alternative NSV flow
3)
• S&W volume flow
3)
1) Only available with the Concentration application package.
2) Only available with the Heartbeat Verification application package.
3) Only available with the Petroleum application package.
Possible input values 11 to 20:
• Off
• Actual diagnostics
• Previous diagnosis
• Mass flow unit
• Volume flow unit
• Corrected volume flow unit
• Temperature unit
• Density unit
• Reference density unit
• Concentration unit
• Current unit
• Totalizer 1 unit
• Totalizer 2 unit
• Totalizer 3 unit
• Verification results
• Verification status
• Status zero point adjustment
Permanently assigned output group
Output assembly fix (Assem102), 54 byte
Description (format) Byte Bit Value
1. Totalizer 1 1 0
• 0: Enable
• 1: Disable
2. Totalizer 2 1
3. Totalizer 3 2
4. Verification 3
5. Concentration of medium type 4
6. Compensation, pressure 5
7. Reference density compensation 6
8. Compensation, temperature 7
9. S&W correction value % 2 0
• 0: Enable
• 1: Disable
10. Water cut % 1
11. Flow override 2
12. Zero point adjustment 3
13. Not used 4
14. Not used 5
15. Not used 6
16. Not used 7