Hardware Installation and Maintenance Manual 5–1
5 - ETHERNET SERIAL SERVER
SpectraSensors SS500e/SS2000e/SS3000e analyzers operate with the Vlinx
ESP902 Ethernet Serial Server that provides Serial-to-Ethernet conversion.
The following information is provided for additional instruction for installing and
configuring the ESP902 Ethernet Serial Server.
SoftwareInstallation
1. Connect a standard Ethernet cable to the ESP902 unit if connecting
to your network, or a crossover cable if connecting directly to a
computer.
a. The default IP address is 192.168.0.1.
2. Insert the software CD (or download from the manufacturer’s
website - http://www.bb-elec.com/ESP90x_Software.asp; from the
“Software” list select ‘Vlinx Vx.x.x.x Software’). The software should
autostart into the installation wizard.
3. Follow the on-screen installation wizard to install the Vlinx ESP
Manager software.
Configuration
1. From the computer, click Start\Programs\B&B Electronics\Vlinx\ESP
Servers\Vlinx ESP Manager.
a. A search for the attached ESP902 device should autostart on
startup.
2. Double-click on the device name from the unit list.
3. Use the Vlinx ESP Manager software to configure the unit for network
information, serial device configurations, timeouts, etc.
a. The default password = <blank>.
b. Reboot as necessary.
The instructions contained in this chapter assume operation will
be conducted by a user with experience in network configuration.
The device must reside on the same subnet to be seen by the
Vlinx ESP Manager software for first-time discovery.
To Next Page
Loading...
Need help?
General
