Epilog Laser LEGEND 24EX 6000 User Manual

Appendix C
Printing From AutoCAD
214
The Pen default
setting is 0.010
inch. The first time
that you print to the
Legend you will
need to set Pens 1-
11 to 0.001 inch.
Select pens 1-11
and change the
Width value to
0.001. Click OK.
Note This is a very
important step in the process of vector cutting from AutoCAD. A pen width of 0.010
will not provide a vector command to the Legend laser system and there will be no
output from the laser.
After returning to the
Print/Plot
Configuration
window, click on the
Device and Default
Selection tab to begin
accessing the Legend
print driver.

Epilog Laser LEGEND 24EX 6000 Specifications

General

Brand	Epilog Laser
Model	LEGEND 24EX 6000
Category	Engraver
Language	English