Section 8: Using the Epilog Legend Systems
79
Diode Pointer
The Diode Pinter setting allows for manually turning ON or OFF the Laser Diode
Pointer (Red Dot Pointer). This visible output beam is much like the hand held laser
pointers, and has a bright red beam. This beam allows the operator to visually note
where the laser is engraving or cutting. While this device employs the same
technology as the familiar laser pen-pointers, like them it is potentially hazardous if
its beam is directed into the eye. For additional information, read Section 2, “Safety”
contained in this manual. Use the diode pointer in conjunction with the Move
X/Move Y coordinates to locate a given position on the engraving table.
Jobs
This is the main access for starting jobs that are stored in the Legend. The Legend
has the capability to store multiple jobs in memory. If there are jobs in the Legend
memory, select the JOBS menu heading and press the ENTER key. The list of valid
jobs in memory will drop down. Highlight the one you want, and press, ENTER.
This will give you the drop down list of options RUN, RUN/OVERRIDE, VIEW, or
DELETE. Highlight the option you want by using the ARROWS to scroll down
through the list. Pressing ENTER will initiate that function... An explanation of drop
down items and operations are listed below.
Run
The machine will begin processing the job that you have selected.
Run/Override
This selection allows you to override the computer controlled Speed and Power
settings that were sent with the job from your computer. To use this selection:
7. Change the appropriate parameters (Speed/Power) in the SETUP menu.
8. Highlight the job that you want to run from the JOBS menu,
9. Press the RUN/OVERRIDE option. The job will run with the manual settings
that you have selected.
View
The LCD will display a facsimile of the job that you have selected. This feature does
not operate in vector mode if SMOOTHING is enabled, or in rubber stamp mode.
To Next Page
Loading...
Need help?
General
