Section 2: Safety
16
The operator of the Legend Model EX 6000 should observe the following general
precautions:
¾ DO NOT disassemble the machine or remove any of its protective covers
while the unit is plugged in.
¾ DO NOT attempt to defeat the door and window interlocks.
¾ DO NOT view directly into the beam of the Laser Diode Pointer.
¾ DO NOT operate the Laser Diode Pointer without the machine’s focus lens in
place. If the unfocused beam strikes a reflective surface, it could be directed
out of the cabinet.
Caution – Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
* * *
The standard reference for laser safety is the American Standard for the Safe Use of
Lasers, Z136.1-2000, developed by the American National Standards Institute (ANSI).
This reference is the basis for many of the federal regulations for laser and laser system
manufacturers, and for the Occupational Safety and Health Administration (OSHA) laser
safety guidelines. It contains detailed information concerning proper installation and use
of laser systems.
While the ANSI standard itself does not have the force of law, its recommendations,
including warning signage, training, and the designation of a laser safety officer, may be
compulsory under local workplace regulations when operating laser systems above Class
I. It is the operator’s responsibility to ensure that the installation and operation of the
Model 6000 Laser System be performed in accordance with all applicable laws.
Copies of ANSI Standard Z136.1-2000 are available from Epilog Corporation or from:
Laser Institute of America
12424 Research Parkway, Suite 125
Orlando, FL 32826
(407) 380-1553
To Next Page
Loading...
Need help?
General
