Epson AcuLaser C1750N User Manual

Values:
IP Mode Dual Stack*
Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode
Uses IPv4 to set the IP address.
IPv6 Mode
Uses IPv6 to set the IP address.
IPv4 Get IP Address DHCP/AutoIP*
Automatically sets the IP address.
BOOTP
Uses BOOTP to set the IP address.
RARP
Uses RARP to set the IP address.
DHCP
Uses DHCP to set the IP address.
Panel
Enables the IP address entered on the operator panel.
IP Address
Manually sets the IP address allocated to the printer.
Network Mask
Manually sets the subnet mask.
Gateway Address
Manually sets the gateway address.
Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and
then on.
Values:
LPR Disable
Disables the Line Printer Daemon (LPR) port.
Enable*
Enables the LPR port.
Port 9100 Disable
Disables the Port9100 port.
Enable*
Enables the Port9100 port.
WSD Disable
Disables the WSD port.
Enable*
Enables the WSD port.
SNMP Disable
Disables the Simple Network Management Protocol (SNMP) UDP port.
Enable*
Enables the SNMP UDP port.
Epson AcuLaser C1750 Series User’s Guide
Using the Operator Panel Menus 137

Epson AcuLaser C1750N Specifications

General

Brand	Epson
Model	AcuLaser C1750N
Category	Printer
Language	English