Epson Artisan 700 - Printer Initialization

Epson Artisan 700 / Epson Stylus Photo PX700W / TX700W Revision C
OPERATING PRINCIPLES Overview 52
Confidential
2.1.5 Printer Initialization
There are four kinds of initialization method, and the following explains each
initialization
1. Hardware initialization
This pri
nter is
initialized when turning the printer power on, or printer recognized
the cold-reset command (remote RS command).
When printer is initialized, the following actions are performed.
(a) Initializes printer mechanism
(b) Clears input data buffer
(c) Clears print buffer
(d) Sets default values
2. Operator initialization
Initialization when resetting the USB software, and the following are performed
(a) Clears input data buffer
(b) Clears print buffer
(c) Sets default values
3. Software initialization
The ESC@ command also initialize the printer.
When printer is initialized, the following actions are performed.
(a) Clears print buffer
(b) Sets default values
4. IEEE 1284.4 “rs” command initialization
The printer recognized the IEEE 1284.4 “rs” command.
When printer is initialized, the following action is performed.
 Initialization when an error occurs.
(a) Initializes printer mechanism
(b) Clears input data buffer
(c) Clears print buffer
(d) Sets default values
 In
itialization in normal operation
(a) Clears inpu
t data buffer
(b) Clears print buffer
(c) Sets default values