72
Using WPS PIN Mode to Connect to a Network
If you have a WPS-enabled wireless router that supports PIN mode, you can use Wi-Fi Protected Setup
(WPS) PIN mode to connect your product to the network.
1. Select the home icon, if necessary.
2. Press the icon.
3. Select Router.
4. Select Start Setup or Change Settings.
5. Select Others.
6. Select PIN Code Setup(WPS).
7. Follow the instructions on the LCD screen to complete WPS setup.
Note: Make sure you press Start Setup within two minutes of activating WPS on your router.
8. Select the return home icon to return to the home screen.
The Wi-Fi icon displayed on the LCD screen indicates your wireless connection status. If the product
is not connected to the network, repeat these steps to try again.
Parent topic: Wi-Fi Protected Setup (WPS)
Related tasks
Setting Up Network Scanning
Setting Up Network Scanning
You can set up network scanning to your product through a direct connection to your product.
First, manually configure your product to connect to your network. Then follow the instructions here to
set up your computer for network scanning using the Epson Scan 2 Utility. Your product must be turned
on and connected to the network.
Note: Make a note of the IP address or host name of the product so you can enter it in these steps.
1. Do one of the following to start the Epson Scan 2 Utility:
• Windows 11: Click , then search for Epson Scan 2 Utility and select it.
• Windows 10: Click > EPSON > Epson Scan 2 Utility.
To Next Page
Loading...
Need help?
General
