Epson RC90 Safety And Installation

1. Safety
Safety and Installation (RC90 / EPSON RC+ 7.0) Rev.6 27
1.6.2 Manipulator
Location
Label
Note
A
Before lo
osening the base mounting
screws, hold the arm and secure it tightly
with a band to prevent hands or fingers
from being caught in the Manipulator.
For installation and transportation of
robots
, follow the directions in this
manual.
B
Do not enter the operation area while the
Manipulator is moving. The robot arm
may collide against the operator. This
is extremely hazardous and may result
in serious safety problems.
C
Hazardous voltage exists while the
Manipulator is ON. To avoid electric
shock, do not touch any internal electric
parts.
D
You can catch your hand or fingers
between the shaft and cover when
bringing your hand close to moving
parts.
Manipulators with bellows do not have
this label for no danger of your hand or
fingers being caught
E
Only authorized personnel should
perform sling work and operate a crane
and a forklift. When these operations
are performed
by unauthorized
personnel, it is extremely hazardous and
may result in serious bodily injury and/or
severe equipment damage to the robot
system.

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English