Epson RC90 Safety And Installation

3. First Step
Safety and Installation (RC90 / EPSON RC+ 7.0) Rev.5
75
3. First Step
This section indicates the procedure to install the development PC EPSON RC+,
and execute simple program after connecting the development PC and Controller
with a USB.
Make sure that the Robot system is installed safely by following the description in
1. Safety and 2. Installation. Then, operate the Robot system in the following
procedures.
3.1 Installing EPSON RC+ 7.0 Software
The EPSON RC+ 7.0 software needs to be installed on your development PC.
(1) Insert the EPSON RC+ 7.0 Setup DVD in the DVD drive.
(2) The following dialog will be displayed. Click <Nest>.

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English