Epson RC90 Safety And Installation

Safety and Installation (RC90 / EPSON RC+ 7.0) Rev.6 iii
TRADEMARKS
Microsoft, Windows, and Windows logo are either registered trademarks or
trademarks of Microsoft Corporation in the United States and/or other countries.
Other brand and product names are trademarks or registered trademarks of the
respective holders.
TRADEMARK NOTATION IN THIS MANUAL
Microsoft® Windows® XP Operating system
Microsoft® Windows® Vista Operating system
Microsoft® Windows® 7 Operating system
Microsoft® Windows® 8 Operating system
Throughout this manual, Windows XP, Windows Vista, Windows 7 and Windows
8 refer to above respective operating systems. In some cases, Windows refers
generically to Windows XP, Windows Vista, Windows 7 and Windows 8.
NOTICE
No part of this manual may be copied or reproduced without authorization.
The contents of this manual are subject to change without notice.
Please notify us if you should find any errors in this manual or if you have any
comments regarding its contents.
INQUIRIES
Contact the following service center for robot repairs, inspections or adjustments.
If service center information is not indicated below, please contact the supplier
office for your region.
Please prepare the following items before you contact us.
- Your controller model and its serial number
- Your manipulator model and its serial number
- Software and its version in your robot system
- A description of the problem
SERVICE CENTER

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English