1-6 Features and General Specifications Rev. A
Confidential
Figure 1-4 Printing area
(*1)
This dimension shows the distance from the manual cutter to the print position.
(*2)
Values for the printing area are calculated (between dot centers) with the wire diameter (0.29 mm [.011
"
]).
Auto Cutter
Partial cut is executed by a command. (A partial cut leaves one point uncut.)
Paper Roll Supply Device
Take-up Device
A take-up device automatically takes the paper roll up in connection with a paper feed motor.
Receive Buffer
Type A: Either approximately 1KB or 40 bytes, selectable by DIP switches.
Type AM: Either 512 bytes or 40 bytes, selectable by DIP switches
Supply device: Drop-in loading
Maximum of 200 dots, 400 positions
76 mm (2.99")
20.2 mm (0.79") (*1)
Cutting position (manual cutter)
[6.76 mm (0.27")]
(*2)
63.34 mm (2.49")
[5.9 mm (0.23")]
To Next Page
Loading...
