5-52 Disassembly, Assembly, and Adjustment Rev. A
Confidential
Main Assembly 11 (Case Unit)
Take-up flange, Take-up flapper spring and Take-up flaps assemblies
1. Hang the projection of Take-up flange with take-up flapper spring.
2. Insert the above take-up flange assembly position of take-up flange and set the one side of
Take-up flap to the Take-up flange.
3. Draw out of the Take-up flap below and set the Take-up flange assembly. In doing so, take
care not to stretch Take-up flapper spring.
4. Set the Take-up flange to the lower case.
Take-up flap
Take-up flapper spring
Take-up flange
To Next Page
Loading...
