Epson WorkForce 600 - Page 167

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
MAINTENANCE Overview 168
Confidential
Figure 6-8. Lubrication on Main Frame (2)
Figure 6-9. Lubrication on the Guide Rail of the Lower Scanner Housing
<Lubrication Point>
Along the contact area between
the back of the Main Frame and
the CR Unit.
<Lubrication Type>
G-71
<Lubrication Amount>
φ 2 mm x 275 mm
<Remarks>
 Use an injector to apply G-71.
 Clean the lubrication point with
a cloth beforehand.
Right Side View
3.4 mm
Lubrication Point ( : x 1)
Main Frame
Main Frame
<Lubrication Point>
On the surface of the Guide Rail
of the Lower Scanner Housing.
<Lubrication Type>
G-45
<Lubrication Amount>
Sufficient quantity
<Remarks>
 Use a brush to apply G-45.
 Follow the procedure below.
1. Move the CIS Assy to the right
and apply grease on the rail.
2. Move the CIS Assy to the left
and apply grease on the rail.
3. If the CIS Assy is
contaminated with grease,
wipe off the grease with a
cloth.
Guide Rail of Lower
Scanner Housing
CIS Assy
2
1