Epson WorkForce 600 - Page 97

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW Revision A
DISASSEMBLY/ASSEMBLY Removing the Housing 98
Confidential
3. Remove the screws (x5) that secure the Upper Housing.
4. Remove the screw that secure the grounding wire.
5. Release the hooks (x2) at the rear of the Upper Housing.
Figure 4-10. Removing the Upper Housing (2)
6. Release the rib on the Mall Right from the Upper Housing.
7. Release the positioning holes (x2) of the Upper Housing in right-to-left order
from the hook (x2) of the Lower Housing, and remove the Upper Housing
from the printer avoiding the Mall Right.
8. Remove the Mall Right and the Mall Left from the Lower Housing (Refer to
Figure. 4-14).
Figure 4-11. Removing the Upper Housing (3)
5
Hook
Rear side
C.B.P. 3x10, F/Zn-3C (6±1kgfcm)
C.B.P. 3x12, F/Zn-3C (6±1kgfcm)
Upper Housing
4
1
2
3
Grounding wire
C A U T I O N
In the next step, remove the Upper Housing with care, since the
Upper Housing and Main Board of the printer are connected with
the Cover Open Sensor Cable and Panel FFC.
Mall Right
Rib
Positioning hole
(Right)
Positioning hole
(Left)
Upper Housing