Erbe APC 300 - Table of Contents

Contents
Chapter Title ........................................................................................ Page
1 How to Use these Operating Instructions? Intended Purpose
of APC 300. ............................................................................................1
2 Notes on Safety......................................................................................1
3 Notes on Safety in the Medical Specialties ........................................
1
4 Installation ..............................................................................................1
5 Changing Cylinders ...............................................................................1
6 Description of the Front and Back Panels ..........................................1
7 Description of the Graphical Interface of the APC 300 ......................1
8 Connection and Actuation Configurations for ERBE
Electrosurgical Equipment in Conjunction with the APC 300 ..........1
ICC 200
1. Configuration APC probe for flexible endoscopes .................................................................... 1
2. Configuration APC handle for APC and ARGON CUT ............................................................. 4
ICC 300
1. Configuration APC probe for flexible endoscopes .................................................................... 7
2. Configuration APC handle for APC and ARGON CUT, electrode handle for
CUT and COAG with two buttons, instrument for BIPOLAR COAG ................. 10
ICC 350
1. Configuration APC probe for flexible endoscopes .................................................................. 14
ICC Software V. 1.06 and V. 1.07
2. Configuration APC handle for APC and ARGON CUT, electrode handle for
CUT and COAG with two buttons, instrument for BIPOLAR COAG ................. 17
ICC Software V. 1.06 and V. 1.07
3. Configuration APC handle for APC and ARGON CUT, electrode handle for
CUT and COAG with two buttons, instrument for BIPOLAR COAG
(This actuation configuration differs from number 2) ........................................ 20
ICC Software V. 1.07 only
4. Configuration APC handle for APC and ARGON CUT,
instrument for BIPOLAR COAG and BIPOLAR CUT ...................................... 23
ICC Software V. 1.07 only