8 • Actuation Configurations for ICC 200
6
Position neutral electrode on the patient. Connect the neutral electrode
to the ICC.
of equipment trolley.
ICC and APC 300.
1. Open cylinder valves of the argon gas cylinders in a clockwise
direction until they stop.
2. Check fill level of the argon cylinders (fill level of the argon cylinders
is in the information line of the standard display). Always keep a full
replacement cylinder ready.
1. Set AUTO COAG field to FORCED.
2. Press selection key again. Displayed: A.60 (APC mode, power limit
60 W).
3. Select the desired power limit.
If an instrument, rather than the HF cable, is connected to the CUT / COAG
socket, you can actuate this instrument using the foot switch!
Select effect and power limit in the AUTO CUT field.
3. Connect neutral electrode
4. Plug in mains plug
5. Switch on
6. Open cylinder valves
7. Set ICC for APC
8. Set ICC for ARGON CUT
WARNING!
To Next Page
Loading...
