6 • Working with the electrosurgical unit
58 / 106
80113-101_V25087
2023-11
1. To change the CUT power limitation, press the Plus/Minus buttons next to the
watt display in the CUT setting area.
2. To change the COAG power limitation, press the Plus/Minus buttons next to the
watt display in the COAG setting area.
Clean unit
1. Clean the unit after each use (see chapter about cleaning on page 89).
2. Clean/disinfect and sterilize all reusable accessories and instruments according
to the manufacturers' instructions.
3. Dispose of single-use parts in line with the local/national regulations and also
the manufacturers' instructions where appropriate.
To Next Page
Loading...
