SAFETY
2-7
5. Use the proper gas for the process and use the proper pressure reducing regulator
designed to operate from the compressed gas cylinder. Do not use adapters.
Maintain hoses and fittings in good condition. Follow the manufacturer's operating
instructions for mounting a regulator to a compressed gas cylinder.
6. Never secure cylinders to work tables or fixtures where they may become part of an
electrical circuit.
7. When not in use, keep cylinder valves closed. Have valve protection cap in place if
regulator is not connected. Secure and move cylinders by using suitable hand trucks.
2.1.8 MOVING PARTS
Therefore:
1. Keep all doors, panels, guards, and covers closed and securely in place.
2. Have only qualified people remove covers for maintenance and troubleshooting as
necessary
3. Keep hands, hair, loose clothing and tools away from moving parts. Do not use
gloves near moving parts.
4. Reinstall panels or covers and close doors when service is finished and before
starting engine.
2.1.9 MALFUNCTION
• Call for expert assistance in the event of a malfunction.
2.1.10 EQUIPMENT MAINTENANCE
Therefore:
1. Always have qualified personnel perform the installation, troubleshooting and
maintenance work. Do not perform any electrical work unless you are qualified for
such work.
2. Before performing any maintenance work inside a power source, disconnect the
power source from the incoming electrical power.
MOVING PARTS – Can injure.
MOVING PARTS - Can cause injuries
WARNING
Faulty or improperly maintained equipment can cause injury or death.
To Next Page
Loading...
