ESAB EMP 285ic 3ph - ROUTINE MAINTENANCE; WIRE-FEEDER ASSEMBLY MAINTENANCE

MAINTENANCE
8-2
8.1 ROUTINE MAINTENANCE
Table 8-1. Maintenance Schedule During Normal Conditions
Interval
Area to maintain
Every 3 months
Clean or replace
unreadable labels.
Clean weld
terminals.
Check or replace weld cables.
Every 6 months
Clean inside
equipment.
8.2 WIRE-FEEDER ASSEMBLY MAINTENANCE
General good practice is to perform this procedure each time a Wire Bobbin is replaced.
8.2.1 WIRE-FEEDER ASSEMBLY CLEANING
WARNING
Always use hand and eye protection when cleaning.