OPERATION
6-20
6.9 WELDING WITH ALUMINUM WIRE
To weld aluminum using the standard supplied torch, refer to MIG torch instruction manual for
replacing standard steel torch conduit liner with a Teflon torch conduit liner.
Order the following accessories:
• Torch Teflon Conduit Liner (PTFE liner), 3 m (10 ft.): See PARTS section (Wire Liner
Table) in the ESAB Torch Instruction Manual (see NOTE above).
• Teflon coated Output Wire-Guide Tube (select size to match wire from Table in
Appendix C).
• U-groove, Aluminum Feed-Roller (select size to match wire from Table in Appendix C).
After completing the instructions in this section return
to Section 6.8 REMOVING/INSTALLING WIRE.
To Next Page
Loading...
