OPERATION
6-23
6.11 REMOVING/INSTALLING WIRE-FEED ROLLERS
Different-size pairs of dual-groove feed-rollers are supplied as standard (Listed in Appendix C as
“DEFAULT” and as “ACCESSORY”). Change the feed rollers to match the wire size/type on the
wire bobbin. See Appendix C for Feed Roller selection. Figure 6-25 shows location of Wire-Feed
rollers. The Pressure Rollers are not replaced.
Figure 6-25. Location of Wire-Feed Rollers and Pressure Rollers
WARNING
POWER SHOULD BE TURNED OFF FOR THIS PROCEDURE.
Gas does not need to be connected for this procedure.
To Next Page
Loading...
