BE SURE THIS INFORMATION REACHES ALL OPERATORS OF THIS EQUIPMENT. EXTRA
COPIES ARE AVAILABLE THROUGH THE ESAB SUPPLIER OR FROM THE ESAB WEB SITE:
WWW.ESAB.COM.
CAUTION
These INSTRUCTIONS are for experienced operators. If you are not fully familiar with the
principles of operation and safe practices for arc welding and cutting equip
ment, we urge
you to read our booklet, "Precautions and Safe Practices for Arc
Welding, Cutting, and
Gouging," Form 52-529. See:
http://www.esabna.com/eu/literature/precautions%20and%20safe%20practices%20fo
r%20arc%20welding,%20cutting%20and%20gouging.pdf
Do NOT permit untrained persons to install, operate, or maintain this equipment. Do NOT
attempt to install or operate this equipment until you have read and fully understand
these instructions. If you do not fully understand these instructions, contact your supplier
for further information. Be sure to read the Safety Precautions before installing or
operating this equipment.
This equipment will perform in conformity with its proper use when installed, operated,
maintained and repaired in accordance with the instructions provided. This equipment
must be checked periodically. Malfunctioning or poorly maintained equipment should not
be used. Parts that are broken, missing, worn, distorted or contaminated should be
replaced immediately. Should such repair or replacement become necessary, the
manufacturer recommends that a request for service advice be made to the Authorized
Distributor from whom it was purchased. This equipment or any of its parts should not be
altered without the prior written approval of the manufacturer. The user of this
equipment shall have the sole responsibility for any malfunction which results from
improper use, faulty maintenance, damage, improper repair or alteration by anyone
other than the manufacturer or a service facility designated by the manufacturer.
To Next Page
Loading...
