ESAB EMP 285ic 3ph - Page 34

TECHNICAL SPECIFICATIONS
4-5
SPECIFICATION
575 V, 3 ph 50/60 Hz
460 V, 3 ph 50/60 Hz
Mild steel solid wire
0.030-0.052 in.
0.030-0.052 in.
Stainless steel solid wire
0.030-0.052 in.
0.030-0.052 in.
Flux-cored wire
0.030-0.062 in.
0.030-0.062 in.
Aluminum
0.030-3/64 in.
0.030-3/64 in.
Bobbin size
4–12 in. (100–300 mm)
4–12 in. (100–300 mm)
Dimensions l × w × h
27.0 × 11.5 × 19.5 in.
27.0 × 11.5 × 19.5 in.
Weight
70 lb.
70 lb.
Operating temperature
14 to104 °F (-10 to+40°C)
14 to104 °F (-10 to+40°C)
Enclosure class**
IP23S
IP23S
Application class***
* Duty cycle
The duty cycle refers to the time as a percentage of a ten-minute period that you can weld at
a certain current without overheating. The duty cycle is valid for 104 °F / 40 °C. For more
information, see section "Duty cycle" in the OPERATION chapter.
** Enclosure Class
The IP code indicates the enclosure class, i.e. the degree of protection against penetration by
solid objects or water. Equipment marked IP 23S is intended for indoor and outdoor use;
however, should not be operated in precipitation.
*** Application Class
The symbol indicates that the power source is designed for use in areas with increased
electrical hazard.